Installing SSL Certificates on iPhone and iPad

Getting the Certificate onto the Device

• With Dermi Atlas Companion: Open the server in the Atlas Companion app, tap Install Certificate, tap Install Certificate again on the screen that opens, and choose Save to Files.
• With a transferred file: Download the certificate from Dermi Atlas Manager, as described in SSL Certificate Setup for HTTPS Access, and send it to the device, for example with AirDrop.

Install Certificate is offered only for a server whose encrypted connection setting is on. After the download, the Install Certificate screen in Atlas Companion shows the Certificate Fingerprint of the downloaded file; check that it matches the Fingerprint under Certificate Details on the SSL Certificate card in Dermi Atlas Manager before installing the profile.

Step 1: Install the Profile

1. Open the certificate file: in the Files app for a file saved from Atlas Companion, or from AirDrop or the message it arrived in. If asked to choose a device, choose the iPhone or iPad in hand, and tap Allow if asked to download a configuration profile.
2. Open Settings and tap Profile Downloaded near the top, or go to General => VPN & Device Management.
3. Tap the dermi-atlas.local profile, tap Install, enter the passcode, and confirm.

Step 2: Enable Trust

1. Go to Settings => General => About.
2. Scroll to the bottom and tap Certificate Trust Settings.
3. Under Enable Full Trust for Root Certificates, turn on the switch for dermi-atlas.local, and tap Continue.

Checking the Connection

In Atlas Companion, the Install Certificate screen reports the certificate as trusted once the app returns to the foreground; tap Continue. If Verify Installation is still offered, tap it. In Safari, open the HTTPS address shown on the Atlas Access card, for example https://192.168.1.100:15045; the page loads without a certificate warning.

Replacing the Certificate

When Atlas has created a new certificate, Atlas Companion shows Cert Required or Cert Changed on the server. In Settings => General => VPN & Device Management, remove the previous dermi-atlas.local profile, then install and trust the new one with the steps above; the server reads Trusted once the app checks it again.

With the certificate trusted, photos can be captured on the device; see Capturing Photos with Atlas Companion.